HP ProLiant DL388 Troubleshooting Manual page 158

1795-Drive Array - Array Accelerator Configuration Error...
...Data does not correspond to this drive array. Array Accelerator is temporarily disabled.
Audible Beeps: None
Possible Cause: Power was interrupted while data was in the array accelerator memory, or the data stored
in the array accelerator does not correspond to this drive array.
Action: Match the array accelerator to the correct drive array, or run ACU
page 71) to clear the data in the array accelerator.
1796-Drive Array - Array Accelerator Not Responding...
...Array Accelerator is temporarily disabled.
Audible Beeps: None
Possible Cause: Array accelerator is defective or is missing. Depending on the array controller model, the
cache may be disabled or the controller might not be usable until this problem is corrected.
Action:
Reseat the array accelerator daughter board if the connector is loose.
1.
If the problem persists, replace the board.
2.
1797-Drive Array - Array Accelerator Read Error Occurred...
...Data in Array Accelerator has been lost.
Array Accelerator is disabled.
Audible Beeps: None
Possible Cause: Hard parity error detected while reading data from posted-writes memory.
Action: Replace the array accelerator daughter board.
1798-Drive Array - Array Accelerator Self-Test Error Occurred...
...Array Accelerator is disabled.
Audible Beeps: None
Possible Cause: Array accelerator failed self-test. Depending on the array controller model, the cache may be
disabled or the controller might not be usable until this problem is corrected.
Action: Replace the array accelerator daughter board.
1799-Drive Array - Drive(s) Disabled Due to Array Accelerator Data Loss...
...Select "F1" to continue with logical drives disabled.
Select "F2" to accept data loss and to re-enable logical drives.
Audible Beeps: None
Possible Cause: One or more logical drives failed due to loss of data in posted-writes memory.
Action:
•
Press the F1 key to continue with the logical drives disabled.
•
Press the F2 key to accept data loss and re-enable logical drives. After pressing the F2 key, check
integrity of the file system and restore lost data from backup.
("Array Configuration Utility" on
Error messages 158