Concluding Steps; Removing 3.5-Inch Hdd Out Of; Inch Dummy Cover; Required Tools - Fujitsu PRIMERGY MX130 S2 Upgrade and maintenance manua Upgrade And Maintenance Manual

HDDs and accessible drives
Ê Connect cables to the HDD.
1 Power cable connector P2 (see
on page
2 SATA cable T26139-Y4028-V153
7.7.4

Concluding steps

Perform the following procedures to complete the task:
Ê Close the front cage as described in section
page 53.
Ê Follow all procedures described in section
Ê Please observe the notes on RAID rebuild in section
array rebuild" on page
7.8 Removing 3.5-inch HDD out of 5.25-inch
dummy cover
7.8.1

Required tools

Preliminary and concluding steps: tool-less
●
Installing a 3.5-inch HDD
●
– Phillips PH2 / (+) No. 2 screw driver
7.8.2

Preliminary steps

Before removing a 3.5-inch HDD, perform the following steps:
Ê Follow all procedures described in section
Ê Open the front cage as described in section
page 52.
Ê Locate the correct drive bay as described in section
page 82.
100
239)
67.
Upgrade and Maintenance Manual
"Power cable T26139-Y4012-V211"
"Closing the front cage" on
"Closing the server" on page
"Performing a RAID
"Opening the server" on page
"Opening the front cage" on
"Mounting order" on
54.
48.
MX130 S2