Removing The Processor Heat Sink - Fujitsu PRIMERGY MX130 S2 Upgrade and maintenance manua Upgrade And Maintenance Manual

11.2.3 Removing the processor heat sink

Figure 117: Removing the processor heat sink
Ê Loosen the four captive screws on the heat sink in a crossover pattern.
Ê Disconnect the CPU fan cable from the system board connector FAN1.
Ê Carefully turn the heat sink back and forth to detach it from the processor.
I
This may be necessary due to the adhesive quality of the thermal
paste located between the heat sink and processor.
Ê Lift the heat sink out of the chassis.
Ê Thoroughly clean residual thermal paste from the surface of the heat sink
and the processor using a lint-free cloth.
MX130 S2
Upgrade and Maintenance Manual
Processors
189