Basic hardware procedures
4.2
Opening the server
V
CAUTION!
Before removing or installing covers, turn off the server and all
●
peripheral devices. Also unplug all power cables from the outlet.
Failure to do so can cause electric shock.
In order to comply with applicable EMC regulations (regulations on
●
electromagnetic compatibility) and satisfy cooling requirements, the
PRIMERGY MX130 S2 server must not run while the server cover is
removed.
For further safety information, please refer to chapter
●
information" on page
4.2.1
Shutting down the server
V
CAUTION!
For further safety information, please refer to chapter
information" on page
I
This step is only required when upgrading or replacing non-hot plug
components.
Ê Inform the system administrator that the server will be shut down and put
offline.
Ê Terminate all applications.
Ê Verify if your backup software solution requires preparative configuration
before starting the procedure as described in section
configuring the backup software solution" on page
Ê Remove all backup and optical disk media from backup and optical disk
drives as described in section
page
60.
48
31.
31.
"Removing backup and optical disk media" on
Upgrade and Maintenance Manual
"Important
"Important
"Verifying and
61.
MX130 S2