Enabling Option Rom Scan; Verifying And Configuring The Backup Software Solution - Fujitsu PRIMERGY MX130 S2 Upgrade and maintenance manua Upgrade And Maintenance Manual

Basic software procedures
5.2.3

Enabling Option ROM scan

In order to configure an expansion card that has been installed or replaced, the
card's Option ROM has to be enabled in the system board BIOS. The card's
firmware is called by the system BIOS upon reboot and can be entered and
configured.
Option ROM can be enabled permanently (e.g. in case of a boot controller that
may require frequent setup) or temporarily for one-time configuration.
When the enabled expansion card is initialized during the POST phase of the
boot sequence, a key combination is displayed temporarily to enter the
expansion card's firmware.
Ê Press the displayed key combination.
Ê Modify the expansion card firmware options as desired.
Ê Save your changes and exit the firmware.
As default setting for this system, Option ROM is enabled for all onboard
controllers and all expansion card slots.
For detailed information on how to access the BIOS and modify settings, refer
to the "D3090/D3091 BIOS Manual".
5.2.4 Verifying and configuring the backup software
solution
I
This task only applies to the Japanese market.
Disabling backup drives
Depending on the backup software solution, it may be necessary to disable or
delete the backup drive from the backup software drive list and reconfigure
backup jobs after completing the maintenance task.
This is the case for the following backup software solutions:
– Netvault for Windows
– ARCServe
– BackupExec
64 Upgrade and Maintenance Manual
MX130 S2