Preliminary Steps; Removing An Additional 3.5-Inch Hdd Out Of The 5.25-Inch Odd/Hdd Bracket - Fujitsu PRIMERGY MX130 S2 Upgrade and maintenance manua Upgrade And Maintenance Manual

7.10.2 Preliminary steps

Before installing a 3.5-inch HDD, perform the following steps:
Ê Follow all procedures described in section
Ê Open the front cage as described in section
page 52.
Ê Locate the correct drive bay as described in section
page 82.
7.10.3 Removing an additional 3.5-inch HDD out of the
5.25-inch ODD/HDD bracket
Figure 46: Cabling of HDD and ODD in 5.25-inch ODD/HDD bracket
Ê Disconnect cables to the HDD.
1 Power cable connector P2 (see
on page
2 SATA cable T26139-Y4028-V153
MX130 S2
239)
Upgrade and Maintenance Manual
HDDs and accessible drives
"Opening the server" on page
"Opening the front cage" on
"Mounting order" on
"Power cable T26139-Y4012-V211"
48.
107