Connecting Cables To The Expansion Card; Concluding Steps; Removing Expansion Cards; Required Tools - Fujitsu PRIMERGY MX130 S2 Upgrade and maintenance manua Upgrade And Maintenance Manual

9.2.1.5

Connecting cables to the expansion card

Ê If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, please refer to section
page 235.
9.2.1.6

Concluding steps

Perform the following procedures to complete the task:
Ê Follow all procedures described in section
Ê After installing or replacing a Modular RAID controller, update the firmware
as described in section
Ê In order to configure an expansion card that has been installed or replaced,
the card's Option ROM has to be enabled in the system board BIOS. If
applicable, proceed as described in section
page 64.
Ê If the new expansion card replaces a previously installed network adapter,
inform the customer about changed MAC addresses. For further
information, refer to section
page 67.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
9.2.2

Removing expansion cards

Upgrade and Repair Units (URU)
Average task duration: 5 minutes
9.2.2.1

Required tools

Preliminary and concluding steps: tool-less
●
Removing expansion cards: tool-less
●
MX130 S2
"Updating RAID controller firmware" on page
"Looking up changed MAC addresses" on
66.
Upgrade and Maintenance Manual
Expansion cards
"Closing the server" on page
"Enabling Option ROM scan" on
"Cabling" on
54.
63.
"Enabling
165