Fujitsu PRIMERGY MX130 S2 Upgrade and maintenance manua Upgrade And Maintenance Manual page 36

Important information
High humidity and airborne dust levels are to be avoided. Electric
●
shocks and/or server failures may be caused by liquids such as
water, or metallic items, such as paper clips, entering a drive.
Shocks and vibrations are also to be avoided.
●
Do not insert any objects other than the specified CDs/DVDs/BDs.
●
Do not pull on, press hard, or otherwise handle the CD/DVD/BD tray
●
roughly.
Do not disassemble the ODD.
●
Before use, clean the optical disk tray using a soft, dry cloth.
●
As a precaution, remove disks from the ODD when the drive is not to
●
be used for a long time. Keep the optical disk tray closed to prevent
foreign matter, such as dust, from entering the ODD.
Hold CDs/DVDs/BDs by their edges to avoid contact with the disk
●
surface.
Do not contaminate the CD/DVD/BD surface with fingerprints, oil,
●
dust, etc. If dirty, clean with a soft, dry cloth, wiping from the center to
the edge. Do not use benzene, thinners, water, record sprays,
antistatic agents, or silicone-impregnated cloth.
Be careful not to damage the CD/DVD/BD surface.
●
Keep the CDs/DVDs/BDs away from heat sources.
●
Do not bend or place heavy objects on CDs/DVDs/BDs.
●
Do not write with ballpoint pen or pencil on the label (printed) side.
●
When a CD/DVD/BD is moved from a cold place to a warm place,
●
moisture condensation on the CD/DVD/BD surface can cause data
read errors. In this case, wipe the CD/DVD/BD with a soft, dry cloth
then let it air dry. Do not dry the CD/DVD/BD using devices such as a
hair dryer.
To avoid dust, damage, and deformation, keep the CD/DVD/BD in its
●
case whenever it is not in use.
Do not store CDs/DVDs/BDs at high temperatures. Areas exposed to
●
prolonged direct sunlight or near heating appliances are to be
avoided.
36 Upgrade and Maintenance Manual
MX130 S2