System board and components
12.1
Replacing the CMOS battery
Upgrade and Repair Units (URU)
Average task duration: 5 minutes
CMOS memory (volatile BIOS memory) and the real-time clock are powered by
a lithium coin cell (CMOS battery). This cell lasts two to ten years, depending
on ambient temperature and use.
If the CMOS battery is depleted or falls below minimum voltage levels, it need
to be replaced immediately.
Safety notes
V
CAUTION!
The CMOS battery must be replaced with an identical battery or with
●
a battery type recommended by the manufacturer.
Keep lithium batteries away from children.
●
Do not throw batteries into the trash can. Lithium batteries must be
●
disposed of in accordance with local regulations concerning special
waste.
For further safety information, please refer to section "Environmental
●
protection" in the PRIMERGY MX130 S2 Operating Manual.
Ensure to insert the CMOS battery the with the positive pole
●
facing up!
12.1.1 Required tools
Preliminary and concluding steps: tool-less
●
Replacing the battery: tool-less; recommended: tooth pick
●
200
Upgrade and Maintenance Manual
MX130 S2