Dsp To Host-Data Transfer - Motorola DSP56012 User Manual

Parallel Host Interface
Host Interface (HI)
4.4.8.2.4 DSP to Host—Data Transfer
Data transfers from the DSP to the host processor are similar to transfers from the
host processor to the DSP. Figure 4-35 on page 4-60 shows the bits in the status
registers (ISR and HSR) and control registers (ICR and HCR) used by the host
processor and DSP CPU, respectively. The DSP CPU (see Figure 4-33 on page 4-58)
can poll the HTDE bit in the HSR (1) to see when it can send data to the host, or it can
use interrupts enabled by the HTIE bit in the HCR (2). If HTIE = 1 and interrupts are
enabled, interrupt processing begins at interrupt vector P:$0032 (3). The interrupt
routine should write data to the HOTX (4), which will clear HTDE in the HSR. From
the host's viewpoint, (5) reading the RXL clears RXDF in the ISR. When RXDF = 0
and HTDE = 0 (6) the contents of the HOTX will be transferred to the receive byte
registers (RXH:RXM:RXL). This transfer sets RXDF in the ISR (7), which the host
processor can poll to see if data is available or, if the RREQ bit in the ICR is set, the HI
will interrupt the host processor with HOREQ (8).
4-56 DSP56012 User's Manual MOTOROLA