Programming; System Menu; Entering The Service Code; Displaying Total Piece Counter - Beisler 2110-5 Working Instructions

Short Seam Automat 2110-5 / 2111-5 Workinging Instructions
D.3
D.3.1 System menu
The system menu is divided into several submenus. The
submenus themselves are divided into access-protected
and open submenus. Access is protected by the service
code.
Open submenus
Open submenus are freely accessible from the start menu:
• Enter service code,
• Clamp motor step test
• Display total piece counter
Access-protected submenus
Access-protected submenus can only be opened after the
service code has been entered:
•

Eprom seam parameters

• Copy seam numbers
• Erase seams
• Enter seam name
• Copy sewing program to memory stick
• Load sewing program from memory stick
• Copy variables (global parameters/special parameters)
to memory stick
• Load variables (global parameters/special parameters)
from memory stick
• Run clamp motor in permanent test
• Test thread cutter
NOTE - System menu control!
The submenus of the system menu are requested and
exited using the same keys. Exceptions from this rule are
indicated by plain text in the corresponding menu.
Request the system menu from the start level:
• Press key.
Confirm input and exit the system menu:
• Press key.

Programming

NOTE - Submenu levels!
All input for the system menus must be started from the
submenu level (1).
To change to the submenu level (1):
• Press key.
The submenus of the system menu can be requested
using either the arrow keys or the function keys.
NOTE - RESET!
As a rule, a RESET should be performed in the system
menu after settings have been changed to reset the ma-
chine to its start position.
• Press key STOP twice

Entering the service code

Entering the service code allows access to the access-
protected submenus of the system menu.
• Press key
• Press key (service code).
• Enter service code numbers using the numeric keypad.
The code is: 50190
• Press key to confirm input.

Displaying total piece counter

With this counter, the total number of finished pieces can
be displayed. The counter cannot be reset.
• Press key.
• Press key (additional programs).
• Press key (piece counter).
The number of pieces : 0000000 is displayed.
- D 63 -
Beisler Automated Sewing Equipment