Clamp Rail Clamping Pressure Adjustment - Beisler 2110-5 Working Instructions

Short Seam Automat 2110-5 / 2111-5 Working Instructions
C.5
C.5.5 Machine set-up
After any works to the main clamp, the clamping pressure
and the alignment of the clamp rail to the needle must be
checked.

Clamp rail clamping pressure adjustment:

1. Check to see if the main clamp exerts pressure to the
sewing piece evenly along the entire length of the rail
by lining up a piece of fabric to the insertion position
and lowering the main clamp.
2. Check clamping pressure by trying to pull the sewing
piece out of the clamp at several locations along the
clamp rail.
Fig. 10: The pressure of the clamp rail
working plate changes as height H decreases.
3. Fig. 11: If clamping pressure is irregular or insufficient,
remove clamp rail and adjust pressure using the two
adjustment screws
rail .
Tightening the adjustment screws will increase pres-
sure of clamp rail to working plate as the overall height
H of the main clamp increases.
4. Repeat adjustment and recheck with lowered main
clamp until clamping pressure is distributed evenly alo-
ng the entire length of the clamp rail.
Maintenance
onto the
on the inner side of the clamp
Fig. 10
Fig. 11
- C 41 -
Beisler Automated Sewing Equipment
Fig. 10/11