Setting The Seam Sequence; Copying Seam Numbers; Erasing Seams - Beisler 2110-5 Working Instructions

Beisler Automated Sewing Equipment
D.3
D.3.1 System menu
Eprom seam parameters
This function allows to copy the factory-programmed fi-
xed seams from the Eprom back to the sewing program.
• Press key.
• Press key (init parameters).
• Press key (Eprom seam parameters).
• Enter seam number 01 using numeric keypad.

Setting the seam sequence

The settings refer to the selected sewing program. The
sequence for sewing the seams can be set at will. When
the sequence is set, existing seam numbers are overwrit-
ten or new seam numbers are written.
• Press key.
• Press key.
The display shows the marking of the sewing program and
the seam numbers.
20 01 02 03
Mark seam number to be changed using cursor:
20 01 02 03
• Press key.
Enter new seam number using numeric keypad:
20 01 04 03
Confirm input and exit menu:
• Press key.
The display shows the new seam sequence.
20 01 04 03
Programming
04
04
04
04
Short Seam Automat 2110-5 / 2111-5 Workinging Instructions
D.3.1 System menu

Copying seam numbers

Use this function to copy the properties of a factory-pro-
grammed sewing program or of your self-configured se-
wing programs into an other sewing program. During the co-
pying process, all seams of a sewing program are transfer-
red so that the existing properties of a sewing program will
be overwritten completely..
1. Request sewing program (destination) and mark desi-
red seam number (source).
• Press key.
2. Enter two-digit seam number using numeric keypad.
• Press key.
• Press key (init parameters).
• Press key (copy seam number).
• Enter two-digit seam number using numeric keypad.
The display shows *O.K. PLEASE WAIT* to indicate that
the copy process has been successfully completed.

Erasing seams

Request sewing program and mark seam number to be
erased using cursor (seam number is underlaid black).
• Press or
• Press key.
• Press key (init parameters).
- D 64 -
key