Preparing The Machine - Beisler 2110-5 Working Instructions

Short Seam Automat 2110-5 / 2111-5 Working Instructions
B.3
B.3.2 Preparing the machine
Prior to the production start, check the supply connections,
connect the machine to the compressed air and power
supply systems and prepare the sewing head.
1. Insert needle, pass top thread through needle and insert
bobbin for bottom thread into sewing head (see working
instructions of sewing head manufacturer or supplier).
2. Connect machine to compressed air supply by inserting
the plug-in connector
hose into the compressed air receptacle in the operating
room. The pressure of the compressed air is reduced to
the required operating pressure of 6 bar by a pressure
reducer . Check manometer
operating pressure is set. The pressure reducer is in-
stalled at the side mounting wall of the worktable.
3. Connect machine to power supply system.
WARNING - Electric shock:
Contact with current-carrying components may cause
a lethal electric shock. Check plug and cable before
connecting machine to power supply system.
• Do not use damaged plugs, sockets or cables to
connect the machine to the power supply system!
• The machine is connected to a power source of 230
V ±10 % at 50/60 Hz.
• Before connecting the machine to the power supply
system, check to see if the ratings of the power
supply system in the operating room correspond
with the ratings on the nameplate at the rear of the
machine.
• If the ratings for voltage (V) and maximum current
(A) do not match, the machine must not be con-
nected.
• Insert the grounding plug into a properly grounded
and fused power socket.
• Make sure that the power supply cable is not sub-
ject to tensile or pressure forces.
4. Turn machine on by moving the main switch
the position I.
The machine is ready for operation.
Operation
of the compressed air supply
to see if the correct
Fig. 9
into
- B 21 -
Beisler Automated Sewing Equipment
Fig. 9