Resetting Line-Up Process; Moving Machine To Zero Position; Stopping A Sewing Program; Turning The Machine Off - Beisler 2110-5 Working Instructions

Short Seam Automat 2110-5 / 2111-5 Working Instructions
B.3
Controlling machine cycle in mode 03:
After each working step the following machine cycle can
be continued automatically. Therefore:
1. Depress, then release footswitch for machine cycle:
• Further machine cycle is fully automatic:
B.3.12 Resetting line-up process
This function depends on the selected machine cycle
mode. It only refers to machine movements that can be
executed before the start of the automatic process.
The machine movements will be reset to start position
immediately.
• Press key
B.3.13 Moving machine to zero position
Prior to starting the production, after machine tests or after
corrections to sewing programs, the machine must be re-
turned to zero position for starting the machine cycle:
• Press key STOP twice.
(See Section B.3.14, Stopping a sewing program).
Operation
B.3.14 Stopping a sewing program
1. Press key STOP.
When the key STOP is pressed, the program stops. All
traveling motions and the sewing process are stopped
immediately.
To restart the machine after a program stop, all functions
must be reset, and the machine must be returned to zero
position by unlocking the program stop switch.
2. Press key STOP twice.
The control program performs a reset.
B.3.15 Turning the machine off
For extended work intermissions, the machine must be
turned off completely.
1. Turn power supply off by moving main switch to 0 po-
sition.
B.3.16 Periodic cleaning of the machine
The machine must be cleaned after large production series
or at least once a day, whichever occurs first.
CAUTION - Danger of injuries!
If the machine is put in motion accidentally, persons
in its direct vicinity may be caught by moving parts
which may cause injuries.
Prior to any cleaning work, disconnect the machine
from the power supply!
• Turn the machine off using the main switch.
• Remove the power plug from the socket and pro-
tect it from accidental reconnection.
Periodic cleaning:
1. Remove fabric residues.
2. Using compressed air, blow off dust and thread resi-
dues at the sewing head, at the working plate, at the
main clamp and at the linear rail.
- B 27 -
Beisler Automated Sewing Equipment