Setting Stitch Lengths And Bar Tacks; Parameters For Clamp Transport - Beisler 2110-5 Working Instructions

Short Seam Automat 2110-5 / 2111-5 Workinging Instructions
D.3
D.3.10 Level 2 special parameters / Lists

Setting stitch lengths and bar tacks

All settings for the configuration of the seam can be chan-
ged using this list.
The minimum and maximum values of input are limited
by the program control unit. Values that are not within the
limits will not be accepted but reduced to the corresponding
minimum or maximum value.
• Press key
The parameter list is shown on the display.
Programming

Parameters for clamp transport

This list is used to make all settings for the clamp move-
ment.
• Press key
The parameter list shown on the display has the following
function:
01 Clamp insertion as seen from right end of rail
02 Stop position 600 mm is a safety value. Only values
higher than 600 mm can be input
03 Settable range: 35 % - 80 %
04 Settable range: 35 % - 99 %
05 Range of the curve where no sewing is performed. If
value "0" is input here, the sewing process starts im-
mediately.
- D 83 -
Beisler Automated Sewing Equipment