Clamp Transport Belt Replacement - Beisler 2110-5 Working Instructions

Beisler Automated Sewing Equipment
C.5
C.5.4 Repairs

Clamp transport belt replacement:

1. Disconnect machine from power supply system.
2. Slide clamp to left until it reaches stop position.
3. Fig. 6: Remove retaining screws
cover and remove cover.
4. Remove two retaining screws from slide roller cover
and remove cover
5. Loosen two belt lock screws
sion .
6. Loosen lock nuts
set screws backward.
7. Fig. 7: Remove two connecting screws
clamp pedestal. Remove belt.
8. Fig. 6: Install new belt to drive roller
roller .
9. Fig. 7: The ends of the belt are fitted with holes
Position the two ends of the belt with the belt clamp
exactly over the holes on the pedestal and secure
them using screws.
10.Fig. 6: Tension belt by tightening two set screws
until the belt can be depressed approx 10 mm with di-
stinct counterpressure at the middle of the transport rail.
Tighten lock nuts
11.Install the two covers
Fig. 6
Maintenance
from drive roller
.
and release belt ten-
of set screws and rotate two
from main
and to guide
and lock screws .
and .
Short Seam Automat 2110-5 / 2111-5 Working Instructions
Fig. 7
.
- C 38 -
Fig. 6/7