Programming Instructions And Machine Setup; General Hints; Selection Of The Setup - Beisler 1500/70 Series Operating Instructions Manual

3
3.1
3.2
2-6

Programming instructions and machine setup

As a factory setting, 2 sewing programs (4 if the machine is equipped with a
pinking mechanism) are contained in the memory of the machine, which can
be selected and used by the operator. These programs had been program-
med based on long experience and should be sufficient for the use of the
machine. The available programs are described in the first part of this manu-
al.
Existing programs can be modified and adjusted to your personal require-
ments. You can also program completely new sewing programs. All modified
or new programs can be copied on a storage module for data recovery
purposes.

General hints

If you want to set or modify certain functions, you have to place the cursor
using the arrow keys on the icon of the function and change the setting using
the Plus/Minus keys.
At several functions you can press the Special key to open a setup page for
the specific function.
The machine setup can be modified on the following pages:
Setup -01 Machine type
Setup -02 Position actor, turn direction, needle position, revs, storing of
error messages, activate access code
Setup -03 Presser foot, photo cell
Setup -10 Inputs and outputs
Selection of the setup pages
1. Position the cursor on the program number and press the Minus key. This
will be displayed:
PROG.
000
DEUTSCH
XXX
2. Position the cursor on the left-handed „x" below the key symbol.
3. Press the Minus key to change the „x" to a zero.
4. Position the cursor on the middle „x" and press the Minus key.
5. Position the cursor on the right-handed „x" and press the Minus key.
6. Position the cursor on the program number 000 and press the Minus key.
: 3400
[ ]