Brother HL-2600CN Service Manual page 364

x
Be sure not to damage the surface of the transfer drum 2 with a vacuum cleaner when
cleaning the areas around the transfer drum 2.
x
Be sure not to contact the nozzle of the vacuum cleaner with the terminals of the
interior. Failure to do so will cause damage to the electrical parts in the printer.
x
It is recommended to ground the nozzle of the vacuum cleaner by using the earth
wire.
4) Media cassette
i) Remove the media cassette from
the printer and remove paper from
the cassette.
ii) Vacuum paper dust in the media
cassette.
iii) Reinstall the media cassette.
6.6 Packing
1) Re-install the fusing unit into the
printer.
i) After setting the fusing unit in place,
lightly press down the unit to firmly
connect to the connector on the
base.
ii) Tighten the securing screws while
pressing down the fusing unit.
Check the metal hook of the screw
at the left hand secures the fusing
unit correctly.
iii) Close the rear access cover and
top cover ASSY 2.
Media cassette
A-17
Fusing unit