Brother HL-2600CN Service Manual page 198

Sequence of Assembling
1) Install the new fusing unit onto the printer.
i) Tighten the securing screws.
ii) Close the paper exit unit cover 2.
When replacing the fusing unit, take time and great care to complete the job
properly. Application of strong force to the fusing unit may result in the failure of the
fusing unit and other parts.
2) Plug the power code into the power outlet and turn on the printer.
3) Upon completion of the warming-up process.
4) Press any of the Menu buttons (+, -, Set or Back) to take the printer Off Line.
5) Press + or – until "RESET MENU" appears.
6) Press Set to proceed to the next menu level, and then press + or – until "PARTS
LIFE" appears.
7) Press Set, and then press + until "FUSER UNIT" appears.
8) Press Set, and then press Go. The printer is now in the READY state.
Note:
When installing the new fusing unit into the printer, you have to wait approximately
for 30 minutes after the unit is installed to allow the fusing oil to circulate in the unit.
Fig.6-22
PRECAUTION
VI-26