Video Controller Mode; Operator Call - Brother HL-2600CN Service Manual

2.

OPERATOR CALL

2.1

Video Controller Mode

The Ready LED is lit and an applicable message appears on the liquid crystal display
(LCD) in the following cases;
1) Consumables require to be replenished.
2) Waste toner pack is full of waste toner.
3) Paper jam.
4) Periodic maintenance.
5) Maintenance work incomplete.
The above cases are not regarded as a breakdown, and should be treated in accordance
with Table 8-1;
TONER EMPTY X
Replace the X toner cartridge.
NO TONER X
Install the X toner cartridge.
COVER OPEN
Close the Front Cover.
COVER OPEN
Close the Top Cover.
COVER OPEN
Close the Rear Access Cover.
COVER OPEN
Close the Lower Feeder Unit Cover.
COVER OPEN
Close the Duplex Unit Cover.
JAM X
Refer to the diagram, and check the location. Remove the
jammed paper.
NO PAPER T1/2
Load paper into Tray 1/2.
WASTE TONER
Replace the waste toner pack.
OIL EMPTY
Replace the oil bottle.
CHANGE FCR
Replace the cleaning roller.
NO OPC BELT
Install the OPC belt.
NO FC ROLLER
Install the cleaning roller.
Table 8-1
Display Message Remarks
X = C, M, Y, K
X = C, M, Y, K
X = A1, A2, B, C, D, E1 ,E2