Brother HL-2600CN Service Manual page 162

46 NVRAM INITIAL
This mode can initialize (data clear) all the data of NVRAM on MCTL PWB 2, and also
can execute NVRAM CLEAR to clear C3 error when occurred.
NVRAM INITIAL is not used under normal circumstances; Bear in mind that execution of
this mode is beset with loss of all the data in NVRAM.
Therefore, all the data in NVRAM should be stored prior to executing NVRAM INITIAL.
Description of Procedures
1) Press the Reprint button after selecting
"NVRAM INITIAL".
o
(a)
2) Select YES if NVRAM should be executed. If
not select NO.
Press the Reprint button so that the RAM
INITIAL will be executed. (All the data will be
cleared.)
4) Following modes shall be executed to set the
RAM data.
43 MARGIN ADJUST
44 LIFE PERIOD SET
45 NVRAM TUNE UP
47 TOTAL PAGE SET
48 EACH IMAGE SET
49 NEXT LIFE SET
* When setting NVRAM TUNE UP, LP TUNE
UP to be set at "-3".
WARNING
(b)
o
(b) (c)
V-37
LCD Message
39 FACTORY MODE
a)
NVRAM INITAL
46 NVRAM INITIAL
b)
YES / NO
39 FACTORY MODE
c)
DP CHECK