Engine Controller Mode - Brother HL-2600CN Service Manual

4.2

Engine Controller Mode

Code
C3
C4
C7
D1
D2
D3
D4
D5
D6
E1
E2
E3
E4
E5
E6
E7
E8
E9
EL
F0
F2
F4
F5
H0
H2
H3
H4
L1
L2
LL
Note:
For further actions for the error messages described in Table 8-4-3, refer to
charts later in this section.
NVRAM Error (MCTL PCB)
Engine Controller MCTL PCB Hardware Error
Process Timing Clock Error (Main Motor Clock Error)
Clutch Error of the Yellow Developing Unit
Clutch Error of the Magenta Developing Unit
Clutch Error of the Cyan Developing Unit
Clutch Error of the Black Developing Unit
HPSI Signal Error (Retract Error of Black and Yellow Toner
Cartridge)
HPSI Signal Error (Retract Error of Cyan and Magenta Toner
Cartridge)
Developing Motor Error
Main Motor Error
Transfer drum 2 Rotational Error
Toner Sensor PCB Error
Transfer roller 2 Solenoid Error
Brush Cleaner Solenoid Error
Brush Cleaner Clutch Error
Fusing Unit Clutch error
Belt Sensor Error
Erase Lamp Error
Control Fan Error
Ozone Fan (1) Error
Fuser Fan Error
Charging HV (DC High Voltage) Error
Fuser Thermistor Error
Fusing Temperature Error (Warming-up Time Error)
Fusing Temperature (3) Error (Heater Continuous ON Time Error)
Fusing Temperature (4) Error (Heater Continuous ON Time Error)
Beam Sensor Error
Scanner Motor Error
Laser Power Error
Description
the flow