4.1.12 Transfer Drum 2
1) Open the transfer unit cover 2.
2) Protect the surface of the transfer drum 2 by covering it with paper.
3) Lift the transfer drum 2 up and forwards from the transfer unit 2 side.
4) Release the transfer drum 2 from the shaft supports.
5) Pull up and remove the transfer drum 2 from the top of the printer.
Note:
N
For easier removal, push the drum upwards and diagonally forwards.
N
When re-assembling the transfer drum 2, slide the drum shaft between the metal
plates and ensure the drum is fully located into the correct retaining position.
Do not touch the transfer drum 2 surface with your bare hands or scratch it. Protect the
drum surface during handling.
Transfer drum 2
PRECAUTION
Fig.7-24
VII-17