Brother HL-2600CN Service Manual page 281

6) Remove the set screws ST3X6 (2 pcs.) to remove the oil pan unit 2 and FU felt
ASSY 2 from the fusing unit.
7) Remove the set screws ST3X6 (2 pcs.) to remove the FU felt ASSY 2 from the oil
pan unit.
8) Remove the set screws (2 pcs.) to remove the low guide from the fusing unit.
FU felt ASSY 2
Oil pan unit 2
9) Remove the set screws ST3X6 (2 pcs.) to remove the heater wire (white) from the
fusing unit.
10) Remove the set screw ST3X6 (1 pcs.) from the left hand side of the terminals on
each of the fusing heater 2 (2pcs.).
11) Remove the set screws ST3X6 (2 pcs.) to remove the lamp holders (2 pcs.).
12) Remove the fusing heaters 2 (2 pcs.), then remove the heater wire.
Low guide
Fig.7-98
Fusing heater 2
Fig.7-99
VII-69
Lamp holder