Brother HL-2600CN Service Manual page 363

2) Drum cleaner 2
i) Remove the cleaner cover by
releasing the two hooks.
ii) Holding the handle located on the
top of the drum cleaner 2, push it
backwards.
iii) Remove the drum cleaner 2 by
lifting it out.
iv) Clean the area where the drum
cleaner 2 is mounted with a vacuum
cleaner and a cloth. (Refer to the
figure as shown on the right.)
3) Inside the printer
i) Remove the upper side cover, side
cover (L), and upper cover from the
printer.
ii) Remove the control fan, and then
remove the waste toner feeder unit.
iii) Vacuum toner around the other side
of the waste toner feeder tube and
inside the printer. (Refer to the
figure as shown on the right.)
iv) Reassemble the waste toner feeder
unit, control fan, upper cover, side
cover (L), and upper side cover.
v) Re-install the drum cleaner 2 and
cleaner cover.
Transfer drum 2
A-16
Handle
Drum cleaner 2
Waste toner
feeder unit