Using A Cable To Set Up Server Access To The Network - Cisco IE-3000-8TC Administration Manual

d) The gateway requires two cables, an Ethernet cable that is connected to the switch and a T1 or E1 cable
that is connected to the PSTN connection. Connect the Ethernet cable for the gateway to the switch. Then,
connect the T1 or E1 cable for the gateway to the PSTN connection.
e) Install backup power, such as a uninterrupted power supply (UPS).
f) If you want to do so, plug the phones into the network. (They do not register to the Cisco Business Edition
3000 until after you configure the system, including the users and phones.)
Step 7 Your server comes preinstalled with a default IP address of 192.168.1.250. To ensure that the server is
recognized by your network, perform one of the following procedures:
•
•

Using a Cable to Set Up Server Access to the Network

Your server comes preinstalled with a default IP address of 192.168.1.250. To ensure that the Cisco Business
Edition 3000 server is recognized by the network, you must either use the Cisco Network Configuration USB
key, as described in
connect a Ethernet cable from the server to a laptop, as described in the following procedure.
Procedure
Step 1 On the laptop, set the IP address to 192.168.1.10 or another IP address from the subnet.
Caution
Step 2 On the laptop, set your subnet to 255.255.255.0 and set the default gateway to 192.168.1.1.
Step 3 Connect the Ethernet cable from the server to the laptop. You may use a crossover cable or a straight Ethernet
cable.
Step 4
If you have a Cisco-provided country pack, licenses, and the Cisco-provided .xls data configuration file on a
USB key, insert the USB key into the server.
Step 5 Log in to the Cisco Business Edition 3000 First Time Setup Wizard by using the default IP address of the
server (192.168.1.250).
After you log in, you may update the network parameters, including the IP address of the server:
• On the Network page in the Cisco Business Edition 3000 First Time Setup Wizard (during the initial
• By uploading the Cisco-provided .xls data configuration file in the Cisco Business Edition 3000 First
Step 6 After you complete the Cisco Business Edition 3000 First Time Setup Wizard and the server restarts, you
may disconnect the Ethernet cable from the laptop and server.
Connect the laptop to the switch. If you have not already done so, connect the server to the switch so that the
setup continues.
OL-27022-01
Using a Cable to Set Up Server Access to the Network, on page 127
Using the Cisco Network Configuration USB Flash Drive, on page 128
Using the Cisco Network Configuration USB Flash Drive, on page
Do not set the IP address of the laptop to the default IP address of the server.
deployment)
Time Setup Wizard (during the initial deployment)
Using a Cable to Set Up Server Access to the Network
Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
128, or you must
127