Cisco IE-3000-8TC Administration Manual page 275

Page In Post-Setup Wizard
Gateway Configuration
Next Steps
OL-27022-01
Description
The Gateway Configuration page displays the list of
CLI commands that you must issue on the gateway.
Before your users can place calls over the PSTN, you
must issue these CLI commands on the gateway.
Some of the CLI commands include your
configuration from the Cisco-provided .xls data
configuration file or the Cisco Business Edition 3000
First Time Setup Wizard; for example, the hostname
for the gateway is included in one of the commands.
You can either save the commands to file so that you
can issue the commands later, or you can copy and
paste the commands immediately onto the gateway
if the gateway is in enable mode. For information on
putting the gateway into enable mode and for
information on issuing commands on the gateway,
refer to the gateway documentation.
To save the commands to file, use a text editor, and
verify that the CLI commands display correctly in
the file after you save it. In some cases, such as with
Microsoft NotePad, the commands may not display
in a format that can be used later for copying and
pasting.
When you copy the commands, make sure that you
copy all text that displays in the section.
To issue the commands on the gateway at a later
time, select System Settings > Gateway; then, click
Generate CLI Commands to Configure the
Gateway under the General tab.
Cisco prioritizes the next steps that you should
perform. For example, Cisco recommends that you
perform a backup before you perform additional
configuration tasks. To perform a backup, choose
Maintenance > Backup.
Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
255