Signing In To The Cisco Business Edition 3000 First Time Setup Wizard; Signing In To The Cisco Business Edition 3000 Administrative Interface - Cisco IE-3000-8TC Administration Manual

Signing in to the Cisco Business Edition 3000 First Time Setup Wizard

Perform the following procedure to sign in to the Cisco Business Edition 3000 First Time Setup Wizard.
Procedure
Step 1 Before you sign in to the GUI for the first time, make sure that the server is recognized on your network.
Step 2 Start a supported web browser. For a list of supported web browsers, see the
on page
Step 3 In the address bar of the web browser, enter either of the following case-sensitive URLs:
• https://<IP address of the server>:8443/cucmadmin/dayonelaunch
• https:// <IP address of the server>:8443
Note
Step 4
If the Cisco Business Edition 3000 link displays, click it.
Step 5 Enter your username and password; then, click Sign In.
Tip
The Cisco Business Edition 3000 First Time Setup Wizard displays.
You can save and exit Cisco Business Edition 3000 First Time Setup Wizard at any time, even if the Cisco
Business Edition 3000 First Time Setup Wizard is not complete. After you log in again, the system remembers
where in the process you were when you logged off and continues with that step.
Note

Signing in to the Cisco Business Edition 3000 Administrative Interface

Perform the following procedure to sign in to the Cisco Business Edition 3000 Administrative Interface.
Procedure
Step 1 Start a supported web browser.
For a list of supported browsers, see the
Note
OL-27022-01
55.
The IP address that you enter depends on which procedure you performed to set up server access to
the network. If you used a cable to set up server access to the network, you may enter the default IP
address of the server. If you used the configure.xml file to set up server access to the network, you
enter the IP address that you assigned in the configure.xml file.
The default username is admin. The default password is BE-3000.
After you complete the Cisco Business Edition 3000 First Time Setup Wizard, you cannot access it
again. After your initial deployment, you can update the majority of your settings and perform
maintenance-related tasks in the Cisco Business Edition 3000 Administrative Interface. (Some settings
cannot be changed, such as the country, locale, and default extension range.)
You cannot sign in to the Cisco Business Edition 3000 Administrative Interface until after you have
completed the Cisco Business Edition 3000 First Time Setup Wizard.
Signing in to the Cisco Business Edition 3000 First Time Setup Wizard
Frequently Asked Questions, on page
Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
Frequently Asked Questions,
55.
67