Performing Upgrade Using An Usb Flash Drive - Cisco IE-3000-8TC Administration Manual

Performing Upgrade Using an USB Flash Drive

Parameter
IPAddress
Subnet Mask
Gateway
Step 3 Save the Network Configuration signature file to the Cisco Network Configuration USB flash drive.
Step 4 Remove the Cisco Network Configuration USB flash drive from the laptop and put it in a location that you
will remember.
Step 5 If you have not already done so, install the Cisco Business Edition 3000 server in the customer LAN and
power it up.
Step 6
Insert the Cisco Network Configuration USB flash drive in Cisco Business Edition 3000. Inserting the USB
flash drive creates a temporary network interface which contains network management information that enables
users to connect to the Cisco Business Edition 3000 server.
Step 7
To connect the laptop to Cisco Business Edition 3000, open a browser window to access the Cisco Business
Edition 3000 First Time Setup Wizard using the IP address that is configured in the Network Configuration
signature file.
Step 8
After you log in, you may update the network parameters, including the IP address of the server, one of the
ways:
• On the Network page in the Cisco Business Edition 3000 First Time Setup Wizard (during the initial
• By uploading the Cisco-provided .xls data configuration file in the Cisco Business Edition 3000 First
Tip
Performing Upgrade Using an USB Flash Drive
The following steps describe how to upgrade an MCS 7890-C1 using an USB flash drive.
1 From the Software Download page on Cisco.com, download the appropriate UCSInstall ISO file.
2 Install a 3rd Party MD5 checksum utility on your system.
Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
458
deployment)
Time Setup Wizard (during the initial deployment)
After you access the Cisco Business Edition 3000 Administrative Interface, you can also generate the
configure.xml file from the Network page and save it to a USB flash drive. (Select System Settings
> Network.)
Description
Enter the appropriate IP Address based on the
customers LAN.
This is a mandatory requirement to change the
network configuration.
Enter the appropriate subnet mask of the customers
LAN.
This is a mandatory requirement to change the
network configuration.
Enter the gateway details of the customers LAN. This
is an optional requirement.
OL-27022-01