Cisco IE-3000-8TC Administration Manual page 424

Setting
Line Text Display
Call Forward No Answer Timeout
No Answer Timeout (sec)
Do Not Disturb
Option
Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
404
Description
From this drop-down list box, select the type of
information that you want to display next to the buttons
for assigned lines on the phones:
• None—Displays the extension of the caller.
• First Name, Last Name—Displays the first and
last name of the caller (in that order).
• Last Name, First Name—Displays the last and
first name of the caller (in that order).
This setting specifies the number of seconds to wait
before forwarding an unanswered call to the phone
number that is configured for the Call Forward No
Answer setting, which exists in the usage profile
(Users/Phones > Usage Profile).
Default—12 seconds
Enter a value from 12 to 300.
When you set the No Answer Timeout value
Note
to more than 180 seconds, the incoming call
over a sip trunk may not get connected to the
forwarded number.
This parameter allows you to specify how incoming
calls get handled with Do Not Disturb:
• Call Reject—If you select this option, no
incoming call information gets presented to the
user. Depending on how you configure the
Incoming Call Alert setting, the phone may play
a beep or display a flash notification of the call.
• Ringer Off—This option turns off the ringer, but
incoming call information gets presented to the
phone, so the user can accept the call.
This setting only applies for phones where
Tip
you turned on Do Not Disturb. You turn
on Do Not Disturb in the phone
configuration (Users/Phones > Phones)
or on the phone itself.
Default—Ringer Off
OL-27022-01