Connecting To The Network - Cisco AS5300 Manual

Connecting to the Network

This section describes how to connect the access server to your network. The cables required to
connect the access server to a network are not provided. For ordering information, contact
customer service (see the section "Cisco Connection Online" in the "Preface") or see the
appendix "" for cable and port pinouts.
Warning
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-
network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV
circuits. Some LAN and WAN ports use both RJ-45 connectors. Use caution when connecting
cables.
Note Connect the alarm port only to a safety extra-low voltage (SELV) source using 22 AWG,
or thicker, copper wire. SELV ratings are maximum 30 Volts AC (RMS), maximum 60 Volts
DC, and maximum 50 VA power. The alarm port is rated for 2.0 Amps maximum current.
Warning
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Caution