Neoware e140 - Thin Client User Manual page 339

If REG_SZ. Contains a registry path to a DWORD value. This
value is read by BDRUPD. If it is not zero the option is pro-
cessed: the Target is written with the value of the option or
emptied if Type=4. Otherwise this key is ignored.
IfNot REG_SZ. Contains a registry path to a DWORD value. This
value is read by BDRUPD. If it is zero the option is pro-
cessed: the Target is written with the value of the option or
emptied if Type=4. Otherwise this key is ignored.
Note that if a key is ignored, BDRUPD will not abandon this option.
It will continue searching for applicable conversions in the subkeys,
if any.
As it may be difficult to write full paths for Target, and some loca-
tions may not be known (hardware dependent IDs, etc), the follow-
ing keywords have been set to help create coherent targets:
This keyword replaces the internal identification
%INTERFACE_ID%
number of a network card. BDRUPD, when finding this keyword,
will replace it with the ID of the network card it has been assigned to
use at installation time. If multiple NICs have been defined,
BDRUPD will update the settings for all of them.
means the information will be set at two locations:
%ACTIVE_NIC%
%SERVICES%\Tcpip\Parameters\Interfaces\%INTERFACE_ID%
%SERVICES%\%INTERFACE_ID%\Parameters\Tcpip
means the following location:
%SERVICES%
\Registry\Machine\System\CurrentControlSet\Services
means the following location:
%CONTROL%
\Registry\Machine\System\CurrentControlSet\Control
DHCP Reference
Native DHCP Options 323