Removing The Server Power Supplies - HP ML530 - ProLiant - 128 MB RAM Setup And Installation Manual

2. If present, remove the Torx T-15 screw from the power supply handle. The
Torx T-15 tool is clipped to the rear panel of the server.
3. Press the port-colored latch on the primary power supply handle (1) and pull it
down (2).
4. Pull the power supply out completely and set it aside for reinstallation later (3).
Figure 5-8: Removing the server power supplies
5. Repeat steps 2 through 4 to release and remove any additional power supplies.
HP ProLiant ML530 Generation 2 Server Setup and Installation Guide
Installing the Rack Server
5-13