HP ML530 - ProLiant - 128 MB RAM Setup And Installation Manual page 282

drive air baffle, removing 3-69
drive blank, removing 3-56, 3-58
drive cages
locations 3-53
power connectors 7-4
required cables 7-5
two-bay hot-plug SCSI 3-52
drive fans 7-4
drivers
health 8-18
IML 8-19
installing with SmartStart 8-15
system management 8-18
updating 8-15
drives
bays See bays
CD-ROM See CD-ROM drives
tape See tape drives
DVD drive
cabling 3-72, 7-9
connectors 7-3
installing 3-66, 3-71
locations 3-53
required cables 7-5
E
ejector lever, hard drive 3-57
electromagnetic immunity A-5
electromagnetic interference A-5
electrostatic discharge, prevention
measures B-1 to B-2
embedded COM port A, disabling 8-8
embedded COM port B, disabling 8-8
embedded NIC
disabling PXE support 8-8
fault tolerance 3-37, 4-4
load balancing 3-37, 4-4
teaming 3-37, 4-4
embedded parallel port, disabling 8-8
environmental requirements 2-2
HP ProLiant ML530 Generation 2 Server Setup and Installation Guide
equipment
Class A A-2
Class B A-2
erasing
non-volatile memory 8-9
system configuration C-22
error messages
PCI Hot Plug, Novell NetWare 4-26
POST D-10
Ethernet, full-duplex 1-6
European union notice A-5
events
printing IML 8-20
severity level 8-19
viewing IML 8-19, 8-21
expansion boards See also expansion slots;
PCI-X technology
adding with NCMCON 4-25
hot installing 4-14
hot removing 4-18
installation guidelines 4-2
peak frequency 4-2
removing with NCMCON 4-24
replacing with NCMCON 4-24
verifying installation 3-41, 3-46
expansion slot covers, removing 3-38, 4-15
expansion slot latches
closing 3-40, 4-16
opening 3-38, 4-15, 4-19
expansion slots
activity status, determining C-7
architecture 3-34, 4-2
detection order 4-5
features 1-5
LEDs 4-10 to 4-12, C-5 to C-8
locations 3-6, 4-3, 5-23, 6-4
recommended population order 4-4
white paper 4-5
external cabling 7-12
external device
connecting methods 3-73
connecting to an expansion board 3-74
Index
Index-5