HP ML530 - ProLiant - 128 MB RAM Setup And Installation Manual page 269

Troubleshooting
Table D-7: Problems After Initial Boot
Problem Possible Reasons
SmartStart fails Error occurs during
during installation.
installation.
CMOS is not cleared.
Server cannot Required operating system
load operating step was missed.
system.
Installation problem occurred.
Problem was encountered
with the hardware you have
added to the system.
Problem was encountered
with hardware added to a new
configure-to-order system
(where available).
D-12
continued
Possible Solutions
Follow the error information provided. If it is
necessary to reinstall, run the System Erase
Utility. Read the caution below. Refer to the
instructions in the Servers Troubleshooting
Guide.
Run the System Erase Utility. Read the
following caution. Refer to the instructions in
the Servers Troubleshooting Guide.
Follow these steps:
1.
2.
3.
4.
Refer to your operating system documentation
and to the SmartStart Release Notes on the
SmartStart CD.
Run RBSU and check the OS Selection menu.
Refer to the documentation provided with the
hardware.
See Chapter 7, "Cabling the Server" to identify
correct SCSI bus cabling configuration for
your unit.
You must complete the factory-installed
operating system software installation before
adding new hardware to the system.
Be sure you are following the instructions
provided in the Factory-Installed Operating
System Software Installation Guide.
Remove the new hardware and complete the
software installation. Then, reinstall the new
hardware.
HP ProLiant ML530 Generation 2 Server Setup and Installation Guide
Note at which phase the operating system
failed.
Remove any loaded operating system.
Refer to your operating system
documentation.
Install the operating system again.