Power Cords - HP ML530 - ProLiant - 128 MB RAM Setup And Installation Manual

Power Cords

The power cord set included in your server meets the requirements for use in the
country where you purchased your server. If you need to use this server in another
country, purchase a power cord that is approved for use in that country.
The power cord must be rated for the product and for the voltage and current marked
on the product's electrical ratings label. The voltage and current rating of the cord
should be greater than the voltage and current rating marked on the product. In
addition, the diameter of the wire must be a minimum of 1.00 mm² or 18AWG, and
the length of the cord must be between 1.8 m (6 feet) and 3.6 m (12 feet). If you have
questions about the type of power cord to use, contact an HP authorized service
provider.
IMPORTANT: Route power cords so that they will not be walked on or pinched by items
placed upon or against them. Pay particular attention to the plug, electrical outlet, and the point
where the cords exit from the product.
HP ProLiant ML530 Generation 2 Server Setup and Installation Guide
Regulatory Compliance Notices
A-9