Enabling Snmp Notifications Using Cli Commands - Dell PowerConnect 54 Series User Manual

Enabling SNMP Notifications Using CLI Commands

The following table summarizes the equivalent CLI commands for viewing fields displayed in the SNMP
Global Parameters page.
Table 6-37. SNMP Notification Commands
CLI Command
snmp-server enable
traps
snmp-server trap
authentication
show snmp
snmp-server engine ID
local {engineid-
string | default}
The following is an example of the CLI commands:
Console (config)# snmp-server enable traps
Console (config)# snmp-server trap authentication
Console# show snmp
Community-String Community-Access
---------------- -----------------
public
Community-String Group name
---------------- ----------
Traps are enabled.
Authentication-failure trap is enabled.
Version 1,2 notifications
Target Type
Address
------- ----
Description
Enables the router to send Simple Network Management Protocol traps.
Enables the router to send Simple Network Management Protocol traps when
authentication fails.
Checks the status of SNMP communications.
Indicates the local device engine ID. The field values is a hexadecimal string. Each byte
in hexadecimal character strings is two hexadecimal digits. Each byte can be separated by
a period or colon. The Engine ID must be defined before SNMPv3 is enabled.
read only
Community Version
--------- -------
View name IP address
--------- ----------
view-1 All
IP address Type
----------
----
Udp Filter To
Port name Sec
---- ------ ---
Configuring System Information
Retries
-------
175