Read The Messages On The Controller Display Panel - HP StorageWorks Modular Smart Array 1500 cs Installation Manual

Read the messages on the controller display panel

Each controller contains an integrated LCD panel. This panel displays
informational and error messages, shows the current status of the MSA1500 cs,
and provides an interface for user input.
To verify that your MSA1500 cs is operating properly, use the arrow buttons on
the LCD panel of the controller and look for the following messages:
Table 8: MSA1500 cs Startup Messages
If the
Go to
controller firmware version.
Modular Smart Array 1500 cs Installation Guide
Message
MSA1500 Startup Complete
Fibre Sub-System Link
Failure
00 Array controller Firmware
ver <version>
MSA1500 Startup Complete
Check the cable connections to the MSA1500 cs
Check the availability of your power source
Review the setup instructions in the previous sections of this guide
Refer to the HP StorageWorks MSA1000 Controller User Guide, included on
the MSA1500 cs Documentation CD and available on the Technical
Documentation page of the MSA1500 cs web site at
http://www.hp.com/go/msa1500cs.
Table 9: "MSA1500 cs
Installation Procedures - All Deployments
The array controller has completed its
power on sequence and is operational.
There is no active fiber connection to the
MSA controller.
This message is expected, because,
although you have physically installed
the HBA in the server, you have not yet
installed the drivers for the HBA and the
MSA1500 cs.
You may safely ignore this message.
The current version of the firmware
running on the controller.
message is not displayed:
Information" on page 86 to record the
Meaning
51