Installing The Sensor Harness And Lcd Cable Harness - Toshiba T2200SX User Manual

6.2 Installing the Sensor Harness and
LCD Cable Harness
CAUTION: Be careful not to damage the microswitch located on the sensor harness.
1. Place the sensor harness in position and secure it with the two (M2x4) screws at the top.
2. Route the LCD cable harness through the top cover. The end with the two connectors and
ferrite core should be positioned inside the top cover.
3. Place the left hinge cover over the LCD cable harness. Make sure the sensor harness wires
are not beneath the hinge cover. Secure the left hinge cover with the one (M2x4) screw.
4. Position the ferrite core on the LCD cable harness between the two protruding areas on the
top cover. Secure the LCD cable harness by replacing the tape over the ferrite core.
5. Route the sensor harness wires alongside the LCD cable harness and replace the three pieces
of tape.
6-6