Call Feature Settings - Cisco Small Business SPA509G Administration Manual

Cisco SPA IP Phone Field Reference
Ext Tab
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide

Call Feature Settings

Parameter
Blind Attn-Xfer Enable
MOH Server
Message Waiting
Auth Page
Default Ring
Auth Page Realm
Description
Enables the IP phone to perform an attended transfer
operation by ending the current call leg and
performing a blind transfer of the other call leg. If this
feature is disabled, the IP phone performs an attended
transfer operation by referring the other call leg to the
current call leg while maintaining both call legs. To use
this feature, select yes. Otherwise, select no.
Defaults to no.
User ID or URL of the auto-answering streaming audio
server. When only a user ID is specified, the current or
outbound proxy is contacted. Music-on-hold is
disabled if the MOH Server is not specified.
Defaults to imusic when used with a Cisco SPA 9000 IP
PBX.
Indicates whether the Message Waiting Indicator on
the phone is lit. This parameter is toggled by a
message from the SIP proxy to indicate if a message is
waiting. You can manually modify it to clear or set the
flag in the Ext 1-6 tab.
Setting this value to Yes can activate stutter tone and
VMWI signal. This parameter is stored in long-term
memory and survives after reboot or power cycle.
Defaults to No.
Specifies whether to authenticate the invite before
auto answering a page.
Defaults to No.
Type of ring heard. This corresponds to the Ring Tone
on the Phone tab. Choose from No Ring, 1 through 10,
User 1, or User 2.
Defaults to 1.
Identifies the Realm part of the Auth that is accepted
when the Auth Page parameter is set to Yes. This
parameter accepts alphanumeric characters.
Defaults to blank.
B
309