Configuring The Cisco Spa 9000 For The Cisco Spa500S - Cisco Small Business SPA509G Administration Manual

Configuring the Cisco SPA500S Attendant Console
Setting Up the Cisco SPA500S Attendant Console
STEP 2
STEP 3
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
available on Cisco.com. See
those guides.
Configure one of the following SIP proxy servers:
• Cisco SPA 9000—See
SPA500S, page 215
supports the Cisco SPA500S).
• BroadSoft—See
SPA500S, page
• Asterisk—See
page 216.
Configure the Cisco SPA500S using the configuration utility. The phone to which
the Cisco SPA500S is physically attached and the computer running the
configuration utility must be on the same network.
CTI must be enabled on the phone for an attached Cisco SPA500S to
NOTE
properly monitor the IP phone's line status when the SIP proxy server type is
set to Cisco SPA 9000. See the "Configuring SIP" section on page 89.

Configuring the Cisco SPA 9000 for the Cisco SPA500S

You must still enable Computer Telephony Integration (CTI) on the Cisco SPA 9000
configuration utility, as shown in the following procedure:
Connect to the web-based configuration utility for the Cisco SPA 9000.
Click Admin Login on the configuration utility page.
If necessary, enter admin and your password, then Advanced.
Click the SIP tab.
SIP Parameters
In the
Click Submit All Changes.
Appendix C, "Where to Go From Here,"
Configuring the Cisco SPA 9000 for the Cisco
(verify that your version of the Cisco SPA 9000
Configuring the BroadSoft Server for the Cisco
216.
Configuring the Asterisk Server for the Cisco SPA500S,
section, select yes from the
for a list of
CTI Enable
drop-down list.
9
215