Selecting A Display Language; Creating A Dictionary Server Script - Cisco Small Business SPA509G Administration Manual

Localizing Your IP Phone
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide

Selecting a Display Language

This section describes how to localize the Cisco SPA300 and Cisco SPA500
Series IP Phone display language. You can define up to nine languages, in addition
to English, to be available and host the dictionaries for each of the languages on
the HTTP or TFTP provisioning server. Language support follows Cisco dictionary
principles.
The WIP310 does not support localization; however, daylight saving time
adjustment is supported.
Use the Language Selection parameter to select the phone's default display
language. The value must match one of the languages supported by the dictionary
server. The script (dx value) is as follows:
• <Language_Selection ua="na">
• </Language_Selection>
Defaults to blank; the maximum number of characters is 512. For example:
<Language_Selection ua="na"> Spanish
</Language_Selection>
During startup, the phone checks the selected language and downloads the
dictionary from the TFTP/HFTP provisioning server indicated in the phone's
configuration. The dictionaries are available at the support website. See
Appendix C, "Where to Go From Here,"
The end user can change the language of the phone on the phone by following
these steps:
Press the Setup button.
Select Language, then press the Select soft button.
Select Option to change the language.
With the desired language selected, press Save.

Creating a Dictionary Server Script

The Dictionary Server Script defines the location of the dictionary server, the
languages available and the associated dictionary. The syntax is as follows:
Dictionary_Server_Script ua="na"/Dictionary_Server_Script
for the website location.
7
199