Call Feature Settings - Cisco SPA942 - - IP Phone Administration Manual

SPA and Wireless IP Phone Field Reference
Ext Tab
Cisco SPA and Wireless IP Phone Administration Guide
Parameter
Auth INVITE
Ntfy Refer On 1xx-To-Inv
Use Anonymous With RPID
Set G729annexb

Call Feature Settings

Parameter
Blind Attn-Xfer Enable
Description
When enabled, authorization is required for initial
incoming INVITE requests from the SIP proxy.
If set to yes, as a transferee, the phone will send a
NOTIFY with Event:Refer to the transferor for any 1xx
response returned by the transfer target, on the
transfer call leg.
If set to no, the phone will only send a NOTIFY for final
responses (200 and higher).
NOTE: Not applicable to the WIP310.
This parameter applies only if <SIP Remote-Party-ID>
is set to yes; otherwise, it is ignored.
If the parameter is set to yes, the FROM header's
display-name and user-id fields are set to anonymous
when the caller blocks his caller-id. If the parameter is
set to no, the FROM header's display-name and user-id
are not masked. The Remote-Party-ID header indicates
privacy=full when the caller wishes to block his caller-
id.
Default: yes.
NOTE: Not applicable to the WIP310.
Configure G.729 Annex B settings.
NOTE Not applicable to SPA525G.
Description
Enables the IP phone to perform an attended transfer
operation by ending the current call leg and
performing a blind transfer of the other call leg. If this
feature is disabled, the IP phone performs an attended
transfer operation by referring the other call leg to the
current call leg while maintaining both call legs. To use
this feature, select yes. Otherwise, select no.
Defaults to no.
B
258