Resyncing A Phone; Rebooting A Phone - Cisco Small Business SPA509G Administration Manual

Provisioning Basics
Upgrading, Resyncing, and Rebooting Phones
NOTE
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide

Resyncing a Phone

You can resync an IP phone to a specific remote profile. The configuration of the
phone you resync will match the configuration of the remote phone. The phone
can be configured to resync its internal configuration state to a remote profile
periodically and on power up.
The phone resyncs only when it is idle.
Use the following syntax to resync a phone's profile to a profile on a TFTP, HTTP, or
HTTPS server:
http://phone-ip-addr/admin/resync?protocol://server-
name[:port]/profile-pathname
• Parameter following resync? defaults to the Profile Rule setting on the web
server Provisioning page.
• Protocol defaults to TFTP.
• Server-name defaults to the host requesting the URL.
• Port defaults to:
- 69 for TFTP
- 80 for HTTP
- 443 for HTTPS
• Profile-path defaults to the path to the new resync profile (for example,
http://192. 1 68.2.217admin/resync?tftp://192. 1 68.2.251/spaconf.cfg).

Rebooting a Phone

You can remotely reboot a Cisco IP phone if needed.
Use the following syntax to reboot a phone:
http://phone-ip-address/admin/reboot
6
174