Wi-Fi Settings (Cisco Spa525G/525G2 Only); Bluetooth Settings (Cisco Spa525G/525G2 Only) - Cisco Small Business SPA509G Administration Manual

Cisco SPA IP Phone Field Reference
System Tab
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
Parameter
Enable LLDP-MED
Network Startup Delay

Wi-Fi Settings (Cisco SPA525G/525G2 Only)

Parameter
SPA525-wifi-on

Bluetooth Settings (Cisco SPA525G/525G2 Only)

Parameter
Enable BT
Description
Choose yes to enable LLDP-MED for the phone to
advertise itself to devices that use that discovery
protocol.
When the LLDP-MED feature is enabled, after the
phone has initialized and Layer 2 connectivity is
established, the phone sends out LLDP-MED PDU
frames. If the phone receives no acknowledgment, the
manually configured VLAN or default VLAN will be
used if applicable. If the CDP is used concurrently, the
waiting period of 6 seconds is used. The waiting
period will increase the overall startup time for the
phone.
Setting this value causes a delay for the switch to
get to the forwarding state before the phone will
send out the first LLDP-MED packet. The default
delay is 3 seconds. For configuration of some
switches, you might need to increase this value to
a higher value for LLDP-MED to work. Configuring
a delay can be important for networks that use
Spanning Tree Protocol.
Description
Set to yes to enable Wireless-G service on the
Cisco SPA525G/525G2.
Description
Set to yes to enable support for Bluetooth devices on
the Cisco SPA525G.
B
244