Hp Netraid-2M Specifications - HP P3410A - NetRAID 1M RAID Controller Installation And Configuration Manual

Appendix A

HP NetRAID-2M Specifications

Parameter
Product Number
Card Size
Processor
Bus Type
PCI Edge Connector
BIOS
Cache Configuration
Firmware
Nonvolatile RAM
Operating Voltage
SCSI Controllers
SCSI Data Transfer Rate
SCSI Bus
SCSI Termination
Termination Disable
Devices per SCSI Channel
SCSI Device Types
SCSI Channels
RAID Levels Supported
SCSI Connectors
Multiple Cards
Battery Backup
150
Specification
P3411A (64-MB cache), P3475A (128-MB cache)
6.875" x 4.2" (half-length PCI)
Intel i960RN @ 100 MHz
PCI 2.1/2.2 - 64-bits @ 66 MHz
3 V or 5 V (Universal)
HP NetRAID BIOS
64-MB or 128-MB SDRAM DIMM with ECC
1-MB flash ROM
32-KB of NVRAM for disk configuration space
5.00 V ± 0.25 V
QLogic ISP12160
Up to 160-MB/sec with Ultra3 drives; 80-MB/sec with Ultra2
drives; 40-MB/sec with Ultra drives
Low voltage differential or single-ended SCSI
Active
Automatic through cable detection
Up to 12 depending on SCSI mode and storage cabinet
Low voltage differential or single-ended SCSI disk drives
Two
0, 1, 5,10, and 50
Two 68-pin, high-density internal connectors
Two 68-pin, ultra-high-density external connectors
Up to six HP NetRAID adapters per system
On-board battery backup circuitry provides approximately 72
hours of data retention for the 64-MB cache and approximately
48 hours of data retention for the 128-MB cache.
Adapter Specifications