To Start Hp Netraid Express Tools; To Disable The Hp Netraid Bios; To Change The Scsi Transfer Rate - HP P3410A - NetRAID 1M RAID Controller Installation And Configuration Manual

Chapter 6
If you need to prevent booting from the HP NetRAID subsystem,
disable the HP NetRAID BIOS.
HP NetRAID Express Tools is a configuration and management utility that
resides in a chip on the HP NetRAID board along with the HP NetRAID BIOS
and firmware. For more information about HP NetRAID Express Tools and its
functions, refer to the HP NetRAID Series User Guide in Information Assistant.

To Start HP NetRAID Express Tools

1. Start the host HP Netserver and watch for the flashing message:
Option: Experienced users may press <Ctrl> <M> for
HP NetRAID Express Tools now.
Firmware Initializing
2. While this message is flashing, press <Ctrl> <M>. When the system
stops scanning, HP NetRAID Express Tools starts and displays the Tools
Management menu.

To Disable the HP NetRAID BIOS

If you want to prevent the system from booting from an HP NetRAID-1M or 2M
adapter, or from the integrated HP NetRAID controller (if present), you can
disable the HP NetRAID BIOS:
To disable the HP NetRAID BIOS for all adapters in the system, choose Disable
BIOS from the Tools Management menu.

To Change the SCSI Transfer Rate

1. If you have installed one or more HP NetRAID-1M or 2M adapters, select
the adapter controlling the SCSI channel on which Fast/Wide or Ultra
SCSI support is to be enabled:
Choose Select Adapter from the Tools Management menu.
Select the adapter controlling the SCSI channel of interest.
2. Choose Objects from the Tools Management menu.
3. Choose SCSI Channel from the Objects menu.
4. Select the channel on which the SCSI transfer rate is to be changed.
76
HP NetRAID Software