HP P3410A - NetRAID 1M RAID Controller Installation And Configuration Manual page 49

Chapter 5
To connect the battery pack, plug the connector on the wire into the connector at
J2 on the battery backup board, as shown in Figure 5-1. The connector is keyed to
make sure the proper connection is made.
Figure 5-1. Plugging in Battery Backup Unit on the HP NetRAID-2M
CAUTIONS 1. The battery pack must be connected when the adapter card
is not plugged in to the Netserver.
2. The adapter is sensitive to static electricity and can easily
be damaged by improper handling. The use of a grounding
strap is recommended.
Installation and Configuration
Wire
J2
41