3 Installation and Configuration
Overview
To install and configure your HP NetRAID-1M or 2M adapter, you need to
perform the following steps. Steps A through M are described in Chapters 4
through 7 of this guide.
Step A. Plan Hardware (Chapter 4 and
Worksheet A)
Step B. Plan Arrays and Logical Drives
(Chapter 4 and Worksheets A
and B)
Step C. Prepare the Adapter (Chapter 5)
Step D. Install the Adapter (Chapter 5)
Step E. Install Cables and Set SCSI ID
Switches (Chapter 5)
Step F. Start HP Netserver Navigator to
Launch HP NetRAID Assistant
(Chapter 5)
Step G. Configure Arrays and Logical
Drives (Chapter 5)
If you are replacing an existing HP NetRAID adapter with an HP NetRAID-1M
or NetRAID-2M adapter, follow the instructions in Chapter 8, "Upgrading to an
HP NetRAID-1M or NetRAID-2M Adapter."
Step H. Save Configuration and
Initialize (Chapter 5)
Step I. Use HP Netserver Navigator
CD-ROM to Prepare Diskettes
(Chapter 6)
Step J. Install NOS and HP NetRAID
Driver (Chapter 6)
Step K. Install NOS-specific
Configuration Utility (Chapter 6)
Step L. Run HP NetRAID Express Tools
(Chapter 6)
Step M. (Optional) Prepare for Online
Capacity Expansion (Chapter 7)
23